Yooksmart GR-09-01 Remote Control User Manual

Contents

Yooksmart GR-09-01 Remote Control

Product Information
The product is a remote control for controlling blinds. It allows you to control up to 9 blinds simultaneously. The remote control has a knob that can be used to adjust the opening percentage of the blinds. It also has buttons for setting favorite positions, opening, closing, and stopping the blinds. The remote control operates on a Lithium Cell CR2450 3V battery.

Product Usage Instructions

To control the blinds:

Each channel on the remote control corresponds to one blind.
To open multiple blinds together, press the corresponding channel numbers in sequence and then press the “Open” button.

To install the battery:

Open the remote control and insert a Lithium Cell CR2450 3V battery.
Make sure to remove any protective covers before use.

To enter setting mode:

Hold the “P1” button for 5 seconds.
A green light flashing indicates that the remote control is in setting mode.
Choose the channel you want to set from 1-9.
The remote control will exit setting mode if you hold the “P1” button for 5 seconds again or if there is no operation for 3 minutes.

To set the favorite position:

Press the channel number for the blind you want to set as the favorite position.
Hold the “P2” button for 3 seconds.
The motor will respond to indicate that the favorite position has been set.

To delete the favorite position:

Hold the “P2” button for 3 seconds.
The motor will respond to indicate that the favorite position has been deleted.

To change the up/down direction:

Hold the channel number button for the blind you want to change the direction of.
Press the “P2” button once.
The motor will respond to indicate that the direction has been changed.

To adjust the shades running speed:

Hold the channel number button for the blind you want to adjust the speed of.
Press and hold the “P2” button for 3 seconds to add speed or reduce speed.
The motor will respond to indicate that the speed has been adjusted.

To delete the top limit position:

Hold the channel number button for the blind you want to delete the top limit position of.
Press the “P2” button once.
The motor will respond to indicate that the top limit position has been deleted.

To delete the bottom limit position:

Hold the channel number button for the blind you want to delete the bottom limit position of.
Press the “P2” button once.
The motor will respond to indicate that the bottom limit position has been deleted.

To delete both the top and bottom limit positions:

Hold the “P2” button for 3 seconds.
The motor will respond to indicate that both the top and bottom limit positions have been deleted.

To set the top limit positions:

Move the shade to the desired top limit position.
Hold the channel number button for the blind you want to set the top limit position of.
Press the “P2” button once.
The motor will respond to indicate that the top limit position has been set.

To set the bottom limit positions:

Move the shade to the desired bottom limit position.
Hold the channel number button for the blind you want to set the bottom limit position of.
Press the “P2” button once.
The motor will respond to indicate that the bottom limit position has been set.

REMOTE CONTROL

PARAMETERS

Example Operation:

If there are 9 blinds, and you want to open blinds 1, 3, and 5 together, the operation method is:
Press 1, 3, and 5 in sequence, and then press “Open”.

INSTALL THE BATTERY

Your blind has been programmed before shipment.
Please use it directly after installation.

INSTALL THE REMOTE HOLDER ON WALL

REMOTE CONTROL PROGRAMMING

ENTER SETTING MODE

Green light flashing indicates setting mode.
Choose the channel you want to set from “1-9”.

It will exit setting mode if hold “P1” for 5s again or no operation for 3 mins.