R12 Carbon Fiber Bicycle Frameset
User Manual
Contents
Frameset Diagrams
The R12’s component parts are listed from 1-14. You will receive all the parts inside your package.
Rear brake hose
Front derailleur cable
Rear derailleur cable
Front brake hose
Sponge tube
Brake & Gear Housing Routing – Mechanical
Route the housing into the down tube of the frame from the hole where each house comes out.
Please measure the correct length of the brake and shifter housing before cutting.
Rear brake hose
Front derailleur cable
Rear derailleur cable
Front brake hose
Sponge tube
Headset Bearing Installation
Please route the cable housing FIRST before install the bearings.
Lightly grease the contact point between metal and carbon surface.
Spacers Installation
Pick the right spacer height to adjust your riding position. Remember to route the housing inside bearing cover ring before routing inside the handlebar.
Seatpost Installation
If needed, change the height of the seats and cut off any extra length. Remember that the minimum insertion is 10 CM.
Mount Fixing Points
Carefully observe the bolt’s length before attempting to tighten.
Safety
WARNING
Properly tighten hardware
always tighten hardware to the specified torque.
Over-tightening hardware could deform or break the hardware or components. Under-tightening hardware could cause hardware or components to become loose. Either situation could damage the bicycle and result in injury to the rider.
WARNING
Reapply threadlocker
All reused-fasteners with pre-applied threadlocker must be cleaned with isopropyl alcohol and have new thread locker applied before re-assembly. If threadlocker is not applied, the fasteners may loosen which could damage the bicycle and result in injury to the rider.
Legend
 |
Apply appropriate grease |
 |
Apply threadlocker |
 |
Torque |
 |
Cable (zip) tie |
Internal Routing Frameset
In order to use the complete internal cables routing, the frame and the fork have to be compatible. Fork: The fork must have a hole for the entrance of the brake front cable in the fork-tube to allow the cable routing up to the exit near front brake caliper.
Traditional Frameset
In case of assembling on traditional frameset, cables will enter close to the levers and will go out from central holes. Here above a picture showing the cables passages.
Shifter/Brake lever Installation
Carefully observe the bolt’s length before attempting to tighten. Use torque wrench to tighten the bolt around 6-8Nm
Installation Guide
Integrated Handlebar Computer Holder
R12 FRAMESET USER MANUAL
www.yoeleobike.com
@yoeleo
Yoeleo