2×4 FT LED Panel Light Fixture
Instruction Manual
Contents
2×4 FT LED Panel Light Fixture
Installation Instruction
LED Panel Light
WARNING:
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING. KEEP THIS INSTRUCTIONS FOR FUTURE REFERENCE
Fixtures must be wired in accordance with the National electrical code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A QUALIFIED ELECTRICIAN WHO IS FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
Important
Risk of fire or electric shock. LED panel Light installation requires knowledge of luminaires and electrical systems. If not qualified, DO NOT try to install. Please contact an electrician.
Risk of fire or electric shock. Suitable for damp locations. Make sure the power is off premier to install.
Risk of fire or electric shock. Suitable for non-insulated surface and frame.DO NOT cover fixture with insulation liner or similar material.
DO NOT install in unstable, loose or breakable surfaces.
DO NOT let objects impact or exert force on the surface of the fixture.
Installation and Electrical Connection
WARNING
RISK OF FIRE,ELECTRIC SHOCK OR PERSONAL INJURY
Before installation, urn power off.
- Select one place to install the luminaires.
For P4 hole size shall be 2FT * 2FT
For P1 hole size shall be 1FT * 4FT
For P7 hole size shall be 2FT * 4FT
- Take out the LED panel, cable contact box and some accessory from cartoon.
- Through the cable and metal conduit to the contact box.
- Connect cables as wiring diagram, green wire to ground, black wire to L, white wire to N. Optional: Gray one to DIM-, purple one to DIM+.
- Bend 4x installation hooks by screw driver. Refer to 5-a, 5-b.
- Put the panel on the ceiling ribs.