Wicked Audio Grid Legion 200 True Wireless Earbuds User Manual

Contents

Wicked Audio Grid Legion 200 True Wireless Earbuds

USER MANUAL

In The Box

In the Box

Crid Legion 200 TWS Earbuds
Charging Case
USB to USB-C Charging Cable
3 Sizes of Cushions
Instruction Booklet

Turning Earbuds On/Off

PowerOn
Opening the case automatically turns on the earbuds and starts the syncing process to one another.

Power On (outside of case)
When outside the charging case and powered off, long press both earbuds for 2-3 seconds (green light will flash) to turn them on.

Power Off
Placing the earbuds back into the charging case and closing the lid will automatically power them down.

Power Off (outside of case)
Long press left or right earbud for 4 seconds to turn off earbuds without putting them in the case.

Charging

Charging the Charging Case
Using the USB-[ charging cable, plug into a power source. While charging the charging case LED will “fade” in and out in RED.
Once fully charged, LED will turn off.

Charging the Earbuds
Place earbuds in charging case to charge earbuds. They will turn off and automatically begin charging.

Tip: Eorbuds will announce “low charge” when they are at 10% battery life.

LEDs

Charging Case Lights:
Fading Red : Charging
Rainbow for 1 min : Full Charge Reached
Lights Off : Fully Charged

Earbud Lights:
On : Gaming Low-Latency Mode
Off : Music Mode
Single Side Flashing Green : Pairing

Functions

Pause/ Play
Double Press
(Left or Right Earbud)

Next Track
Triple Press
(Right Earbud)

Enter/ Exit Gaming Mode
Long Press 2 Seconds (Right Earbud)
Note: Gaming mode turns on Earbud LEDs and improves latency.

Volume Up
Single Press
(Right Earbud)

Volume Down
Single Press
(Left Earbud)

Enter/ Exit Voice Assistant
Long Press 2 Seconds (Left Earbud)

Answer Call/Hang up Call
Double Press (Left or Right Earbud)

Reject Incoming Call
Long Press 2 Seconds
(Left or Right Earbud

Troubleshooting

Reset

Only one earbud connecting to device at a time?

1. From your devices Bluetooth menu, delete “Wicked CL200” pairing name.
2. Place both earbuds in charging case.
3. Remove earbuds from charging case.
4. Double Press left earbud, pause, and press 5 more times. (You will hear a “power down” sound.)
5. Set the left earbud aside and repeat Step 4 with the right earbud.
6. Place both earbuds in the charging case and close the lid.

PRECAUTIONS

LISTENING AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE.

Over exposure to excessive sound levels can damage your ears resulting in permanent noise-induced hearing loss {NIHL). Please use the following guidelines established by the Occupational Safety Healtti Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.

SAFE USE 6- HAZARD WARNINGS

90 dB SPL at 8 hours	95 dB SPL at 4 hours	100 dB SPL at 2 hours	105 dB SPL at 1 hours
110 dB SPL at 30 min	115 dB SPL at 15 min	120 dB SPL: Avoid as damage may occur

LIMITATION OF LIABILITY Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.

LIMITED ONE-VEAR WARRANTY

Keep your receipt to obtain warranty service.
Go to www.wickedaudio.com for more details.