VIGOR DR1500DQ Rear Suspension Enhancement System Kit Installation Guide
Contents
INSTRUCTION
- A. HOLLOW RUBBER SPRING (2)
- B. AEON LCOATOR 3.15 ODx V THK (2)
- C. HCS M10x50x 1.5 F/T GR &8 Z (2)
- D. NYLOCK LOCKNUT MIO 1.5GR 8.0 Z (2)
Clearance Instructions
Rear SES Kits for Pick-Ups and Vans should have a 1/2″ to 1-1/2″ gap between the rubber spring and contact point when empty.
A partial load, or vehicle accessories will reduce or eliminate the gap.
Front SES kits are usually in full contact. Medium and Heavy-Duty Trucks, Trailers and Motorhomes wHI be in constant contact, and have no gap.
- Raise vehicle allowing the axle to hang freely.
- Remove existing bump stop by prying out of bump stop cup.
- Position spring assembly into bump stop cup.
- Use soapy water and position spring assembly into bump stop cup. Push and twist simultaneously.
- Ensure assembly is properly seated in bump stop cup.
- To ensure that the assembly is property seated in the cup, it will help to place a temporary spacer such as a short piece of 2×4 wood between the axle and the assembly.
Customer Services
If you have any questions about this product, please contact us below:
Phone : + 1-604-636-8654 (Monday– Friday, 8 am – 6 pm PST)
Email: [email protected]
Thank you very much!