TELTONIKA FMP100 Cigarette Lighter Tracker with Buzzer Owner’s Manual
Contents
DEVICE YOUR KNOW
- SIDE VIEW (WITHOUT COVER)
- FRONT VIEW (WITHOUT COVER)
DEVICE YOUR UP SET
BATTERY THE CONNECT AND CARD SIM-NANO-MICRO INSERT TO HOW
- NANO-SIM TRAY INSERT
Insert the NANO-SIM tray removal tool into the hole on the NANO-SIM card tray and then push until the tray pops out. - DEVICE COVER SPLIT
split device cover to access battery connector inside. - BATTERY CONNECTION
Connect the battery as shown to device. - ATTACHING COVER BACK
Gently close device cover back. - NANO-SIM CARD INSERT
Insert NANO-SIM card as shown with PIN request disabled or read Security info’ how to enter it later in Teltonika Configurator’. Make sure that NANO- SIM card cutoff corer is pointing forward to slot. NANO-SIM slot 1s closer to PCB, NANO-SIM slot 2 is the upper one. - DEVICE IS READY
Screw in all screws. Device is ready to be mounted.
PC CONNECTION (WINDOWS)
- Power-up FMP100with DC voltage (10 – 30 V) power supply using supplied power cable. LED’s should start blinking, see “LED indications™.
- Connect device to computer using Micro-USB cable or Bluetooth connection:
- Using Micro-USB cable
- You will need to install USB drivers, see “How to install USB drivers (Windows)*
- Using Bluetooth
- FMP100 Bluetooth is enabled by default. Turn on Bluetooth on your PC, then select Add Bluetooth or other device >
Bluetooth. Choose your device named – “FMP100_last_7_imei_digits”, without LE in the end. Enter default password 5555, press Connect and then select Done.
- You are now ready to use the device on your computer.