Contents
SDXYSTCE B0714HWPJV 5 Shelf Storage Rack
5-Shelf Storage Rack
Contents: Before getting started, ensure the package contains the following components: NOTE: The extra components in the package as gift can be replaced in the future.
parts
Assembly
Step 1 Insert the protective covers
- Insert all 4 bottom protective covers
to bottom 
and insert all 4 top protective covers 
to top . - Note: Do not omit this step, which could protect your floor from scratches.
Step 2: Setting Up the Brace
- Slide the rivets of brace
into the post- of your desired location with the key slot pointing down, and the shelf ledge of brace facing up. Tap lightly the seat rivets. - Note: Make sure all the rivets are fully seated into the post slots. You may want to use the mallet (included) to help push the rivets into the post slots. This applies to all the rivets used in this unit
Install as follows
Step 3: Setting Up the Beams and the Braces
- Repeat the previous step 2 to attach beams
and braces to postsuntil the first and the second levels are assembled - Note: Each of the beams and braces on the same level should be at the same height
Step 4: Setting Up the Upper Pos
- Put the connector G into the top of the bottom post to install the upper post
Step 5: Set up three back beams.
- Please note that the middle beam near the connecter to increase firmness.
- Moreover, It is easy to assemble upper press boards by only installing the back beams.
Step 6: Setting up the bottom press boards.
- Setting up the third beams and layer.
Step 7: Repeat step 6 to assemble the remaining beams and press boards.
Safety and Compliance
Please read and understand this entire manual before using the product.
CAUTION
- Be aware of dynamic loading! Sudden load movement may briefly create excess load causing product failure.
- Evenly distribute the weight on each shelf, and keep the heaviest loads on the bottom shelf.
- Use only on flat, level, and hard surfaces capable of supporting the shelving and any items placed on it. Remember to only use the shelf on level ground with evenly distributed weight.
- Do not store flammable liquids in the unit unless they are secured in an approved container.
- Keep bystanders out of the area during assembly.
- This product is not a toy. Do not allow children to play with, on or near the unit.
WARNING
- Do not stand on, step on, or alter this unit for anything outside the designed function of storage.
- Use care when handling and assembling metal parts.
- The metal may have sharp edges or corners. The use of protective gloves is recommended.
- Always remember to use proper lifting techniques when moving the boxed or assembled unit.
Preparation
Before beginning assembly of a product, make sure all parts are present. Compare parts with the package contents list. If any part is missing or damaged, do not attempt to assemble the product. It is recommended that this product be assembled on a clean, soft surface, such as a piece of cardboard. The assembling task can be performed by one person but the availability of a second person will make the task simpler.
Tools Required for Assembly ( included): mallet, a pair of gloves
Troubleshooting
| PROBLEM | |
|
The shelf is not level. |
. POSSIBLE CAUSE. CORRECTIVE ACTION
Beam(s) or brace(s) used for the same Re-assemble beam(s) or level are not at the same height or they brace(s). . are assembled upside down. Rivets on the beam(s) or brace(s) are Fully seat the rivets. . not fully seated into the post slots. The ground is uneven or too soft. Move the shelf to a flat, level and hard surface. |
Installation video
Use your mobile phone to scan the QR code to watch the installation video