REGIOLUX 6040 LED Cuawf Surface Mounted Luminaires Instructions

CUAWF-LED
6040
Instructions

Contents

6040 LED Cuawf Surface Mounted Luminaires

This luminaire contains a light source of energy efficiency class C

Safety Information

General Safety Information

Installation, commissioning and maintenance only by qualied electrician.
Never perform any work on the luminaire with voltage applied. Danger to life due to electric shock!
Electric connection must be appropriate according to all applicable standards and other national and international safety and accident prevention regulations.
Damaged luminaires must not be operated.
Observe and retain safety instructions and mounting instructions
No liability is accepted for damages resulting from improper use.
Use genuine parts only for repair.
Ensure stability of the ceiling and fastening elements.
The luminaire is exclusively intended for interior rooms and ambient temperatures not exceeding 25°C, unless otherwise described by labeling the luminaire.

Operation of the luminaire

Abnormal dark spots may be an indication of partial failure of LEDs. Inspect regularly and replace the luminaires affected.
The light source (LED) of this luminaire must not be exchanged or replaced by the user.
Exceeding the permissible ambient temperature will reduce the luminaire’s lifecycle, resulting in premature failure in extreme cases.
Avoid condensation of the luminaire.
Any mechanical load to the LED circuit boards is not permitted.
LEDs can be damaged by electrostatic discharge (ESD).
This may result in total failure. Always avoid direct contact.
Depending on their concentration, chemicals can corrode the LED modules and lead to reduction of luminousux, drift of luminous colour and/or total failure. Always avoid direct contact with acids, bases, solvents, volatile organic compounds and/or oils. Ensure suficient ventilation to prevent damage by gas release.
Avoid ESD problems by not routing feed-through wiring directly along the wiring of the luminaire.
Connect control inputs of dimmable luminaires with standard cables suitable for power supply voltage.

Changes to our products
Modification, reworking, re-marking of products can have a negative impact on their technical properties, destroy them and possibly cause consequential damage to other objects.
The manufacturer cannot be held responsible for damage caused by such changes.
+ IP5x – dust nonconductive
+ IP6x – dust conductive and dust nonconductive

Information for service, cleaning and disposal of luminaire

Instruction for luminaire service:Instruction for end of life:
Switch off, switch off suply to luminaireRemove battery for disposalRemove luminair for disposalDispatch materials to WEEE recycling plantInstruction for luminaire cleaning
Clean luminaireSwitch off, switch off suply to luminaireClean outside luminaire Remove optic Clean inside luminaire Refit opticMake functional test