Contents
RANGER DESIGN 5041 Raised Base for 5040 Cab Box
REQUIRED ITEMS
- Cordless Impact
- Ratchet
- T40 Torx Bit
ASSEMBLY
SETUP
Unpack all the components and compare with the bill of materials
Verify all parts are present
BILL OF MATERIALS
| Item No. | Description | Qty. |
| 54-613 | Transit 2020, Cab Box Support, Front | 2 |
| 94-5005 | Assembly Fastener Kit | 1 |
Fastener kits.
94-5005 Fastener Kit Fastener Assembly
INSTALLATION
- To mount both cab box brackets, both front seats need to be loosened from their base.
- On each seat, remove the 2 inner Torx bolts and loosen the 2 outer Torx bolts.
NOTE: Move the seats forward and rearward to gain access to the bolts
- Place the cab box brackets over the seat bases. Take note of the orientation.
- Replace the seats.
- Install the Torx bolts using the recommended factory torque setting
INSTALL WITH 5040 CAB BOX
- Install the Clip-On Nuts on the underside of both cab box brackets
NOTE:
If there is a hand brake, use the side slots on both box supports. If there is no hand brake, use the center slots on both box supports.
HARDWARE USED
#94-201 Nut, Clip-On - Place and attach the 5040 Cab Box on the brackets
NOTE: 5040 Cab Box is a separate unit
You have successfully installed your 5041 Raised Base. Thank you for doing business with us. Ranger Design
For any feedback or suggestions you may have, please contact: [email protected]
For technical support, contact us at 1-800-565-5321 5041 Installation Guide | REV. C1 | Page 7