Contents
Nilight 2PCS LED Light Bar
LED Light Bar Wiring Harness
Installation
- Connect light bar wires to wiring harness terminals respectively, black to black, red to red, yellow to yellow.
- Connect wiring harness to the car battery. Red wire (+) with fuse to positive, black wire(-) to negative
- Turn on the power and press switch on/off to test the light
Caution:
- The operating voltage is 12V DC
- Please make sure all the exposed wire were securely wrapped by electrical insulating tape to prevent short circus
- Please strictly follow the instructions avoid any hazards. If you do not feel comfortable with the installation we recommend having a professional to install or install under his guidance
6 MODE
- Power-off Memory Function Auto restores the state of the last working mode.
- Function Press the Mode button 3 seconds to reset the light modes