ITECHWORLD 2420 Solar Blanket Kit User Manual

Contents

Make sure your battery has enough voltage for the controller to recognize the battery type before first installation.
The battery cable should be as short as possible to minimize power loss.
This solar regulator is preset to suit lithium lon batteries. (Please set the controller to the correct battery type when using.)
The charge regulator is only suitable for regulating solar modules.Never connect another charging source to the charge regulator.
The controller will get hot when it is working, please install the controller on a smooth.well ventilated surface

Built-in industrial micro controller.
LCD display with adjustable parameters.
Fully 3-stage PM charge management.
Built-in short-circuit protection, open-circuit protection, reverse protection, and over-load protection.
Dual mosfet reverse current protection,low heat production.

menu:switch between different display, or to enter/exit setting by
long press. up: press to increase
value. down: press to decrease value.

Attn:

Press the [down] button to on/off load manually at the main display
The work mode is working as below:
- [24HILoad output 24 hours
- [1-23H]Load on after sunset and closed after, setting hours

Trouble Shooting
Situation		Solution
Charge icon is not on when sunny	The solar panel opened or reversed	Reconnect
Load icon off	Mode setting wrong	Set again
Load icon off	Battery low	Recharge
Load icon slow flashing	Over load	Reduce load watt
Load icon fast flashing	Short circuit protection	Auto reconnect
Power off	Battery too low/ Reverse	Check battery/ Connection