Contents
hansgrohe 15073000, 15073400 PuraVida
Product Information
The product is a shower system, which can be used for bathing, hygienic and body cleansing purposes. The shower system requires hot and cold water supplies of equal pressures to function properly. The product comes with technical data including a maximum operating pressure of 1 MPa and a recommended operating pressure of 1.6 MPa. The product also has a flow diagram, dimensions, spare parts information, and a test certificate. The product is available in two colors: chrome plated and white/chrome plated.
Product Usage Instructions
When installing the product, it is recommended to wear gloves to prevent crushing and cutting injuries. The hot and cold water supplies must be of equal pressures to ensure proper functioning of the shower system. The installation instructions are provided on page 31 of the user manual. To operate the shower system, turn on the water supply and adjust the temperature to your liking. The product comes with a flow diagram to help understand the different settings. The operation instructions are provided on page 34 of the user manual. To clean the product, use a non-acidic cleaner and avoid using silicone containing acetic acid. The cleaning instructions are provided on page 38 of the user manual.
Safety Notes
- Gloves should be worn during installation to preventcrushing and cutting injuries.
- The shower system may only be used for bathing, hygienic and body cleansing purposes.
- The hot and cold supplies must be of equal pressures
Installation Instructions
- The fitting must be installed, flushed and tested after the valid norms.
- If the instantaneous water heater causes problems or
- if you wish to increase the water flow, the EcoSmart® (flow limiter) located behind the aerator can be removed.
- Hansgrohe mixers can be used together with hydraulically and thermically controlled continuous flow heaters if the flow pressure is at least 0,15 MPa
Technical Data
This mixer series-produced with EcoSmart® (flow limiter)
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0,1 – 0,5 MPa
- Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
- Hot water temperature: max. 80°C
- Recommended hot water temp.: 65°C
Assembly
Do not use silicone containing acetic acid!
Dimensions
Flow diagram 
- with EcoSmart®
- without EcoSmart®
Spare parts
- XXX = Colors
- 000 = chrome plated
- 400 = white/chrome plated
Operation
Cleaning
Test certificate
Hansgrohe · Postfach 1145 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440
E-Mail: [email protected] · Internet: www.hansgrohe.com