WS482110 Warming Drawer
Instruction Manual
WS482110
Contents
WS482110 Warming Drawer
You must note the following Electrical connection The appliance must only be connected to a earthing contact socket that has been correctly installed. A socket must only be installed or the power cable replaced if this is carried out by a qualified electrician, and in accordance with the appropriate regulations.
The appliance must only be connected using the power cable provided. Connect the power cable to the back of the appliance. Connecting cables with various plug types are available from after-sales service.
No multi-plugs, multiple connectors or extension leads may be used. Overloading causes a risk of fire.
If the plug can no longer be reached after the installation, a partition must be provided in the phases in the permanent electrical installation in accordance with the installation regulations.
Fitted units
The fitted cabinet must not have a back panel behind the appliances. There should be a gap of at least 35 mm between the wall and the cabinet base as well as the rear panel of the cabinet situated above.
Ventilation slots and intake openings must not be covered.
Read the information in the installation instructions for the appliance installed above. Do not install the appliance behind a decorative panel, as this puts the appliance at risk of overheating.
Installing the appliance
Mount and align the hook. Attach the edge protector to the centre of the back of the appliance.
Connect the appliance to the mains. Then align the appliance flush with the unit and screw it in place.
Note: Ensure that the connector lead does not become trapped or bent.. After installation the connector lead must not be in contact with the back or the base of the appliance.
900128075 961216