METAL CABINET ASSEMBLY INSTRUCTION
NOTE:PLEASE AN ASSISTANT IS REQUIRED ES NECESARIO UN AYUDANTE UN ASSISTANT ESTNECESSAIRE.
Please scan the QR code to check the assemble video
 |
 |
 |
 |
|
| A: Back plate *2 | B: Side plate *2 | C: Roof plate | D: Base plate | |
 |
 |
 |
 |
|
| L: Left door | R: Right door | E: Shelving | K: Expansion screw *4 | |
 |
 |
 |
 |
 |
| 5mm X 10mm G: Self-tapping screw 12 pcs |
6mm X 25mm F: Screw 18 pcs |
H :Shelving bracket 4 pcs | 0.8mm X 9.5mm Door-hinge pad 2 pcs |
5mm X 24.5mm |
Connect C and D to side plate B.
Align with the corresponding screw holes.
Then secured with 8 pcs screws F.
Attention: Don’t tighten the screws until after the cabinet has been installed
1.Installation of roof and base plates
Connect B with C, D. Align with the corresponding screw holes.
Then secured with 8 pcs screws F
Attention: Don’t tighten the screws until after the cabinet has been installed
2.Installation of right side plate
As shown, turn the cabinet 90 degrees to face up
3.Right the cabinet
Link A with roof, base, left and right side plate.
Align with the corresponding screw holes.
Then secured with 8 pcs 5 x 10 screw G.
Link between A with two screws F.
4.Installation of back plate
Align separator plate buckle H with corresponding holes, and put in 4 pcs in order.
Tilt the partition E into the cabinet.
Made it level then down.
Place it accurately into the laminate buckle slot.
5.Installation of Shelving and Shelving bracket
Press down on the upper door spring door hinge, align it with the upper top door hinge hole and release the hand to allow it to enter accurately.
Align the lower door hinge J with the corresponding the holes in the bottom. Place the washers in order. Align lower door hinge holes of door plate J and H with the corresponding door hinge.
6.Installatin of left and right door plate.
If need to hang the wall, could perforat the wall and use screws K to fix the cabinet.
If don’t need it, could put any place to use directly. Completely