Fabuletta FKT Electric Coffee Kettle Pour Over Gooseneck
Contents
Filling Water
- We recommend using filtered or purified water.
Avoid using tap water, because the mineral content is too high and will be easy buildup of the limescale or brown spots on the heating plate.
- Add at least 1 US cup/236ml of water to the kettle.
Do not fill above the MAX line, because the water may boil over and potentially splash out.
- Put the lid on the kettle with vent holes facing towards to the handle. Wipe any water outside of the kettle.
Place the kettle onto the base.
- When filling or carrying the kettle, do not tilt it backwards, as this may allow water to pass through the steam tube onto the control area.
Operating The Kettle
- Plug the kettle into the power socket. The rated voltage of the kettle is 120Vac. Never apply a voltage greater than the rated voltage, which will damage the kettle and cause the water boil over and splash out.
- Press the On/Off Switch down. The blue indicator light will turn on and the kettle will start to heat up. The kettle will automatically turn off after the water has boiled.
- When boiling – hot steam will be emitted from the kettle. The lid, kettle body and the decorative ring of the handle become hot.
- When pouring – please use the handle for lifting, carrying and pouring. Pour slowly and do not over-tilt the kettle. Pour all hot water from the kettle before opening the lid.
Troubleshooting Guide
| Kettle will not turn ON | |
| Possible Cause | Solutions |
| The kettle may not be properly connected to the power supply. |
|
| The kettle may not be properly connected to the power base |
|
| The kettle is accidentally switch on without water, cause Boil dry feature activated. | Wait approximately 5 minutes for the kettle to cool down and then refill as normal. |
| The heating element may have been broken if the indicator light illuminate but the kettle does not boil | Please contact Fabuletta Customer Support Team for further assistance via e-mail [email protected]. |
| Kettle will not switch Off | |
| The amount of water in the kettle is too little | Please fill the kettle with at least one cup of water (8 US fl. oz/ 237ml). |
| The lid is not placed properly | Place the lid on the kettle and check if it close properly. |
| You may use the kettle at an high altitude area that exceed 2000 meter | Please contact Fabuletta Customer Support Team for further assistance via e-mail [email protected]. |
| Water leaks from the bottom | |
| You may have over filled the kettle. | Please do not fill above the MAX line. |
| Water go through the steam tube |
|
| Water droplets collects on top power base | |
| This is condensation and perfectly normal. | Dry with non abrasive cloth. |
| There are small brown spots on the heating plate | |
| This is normal, small deposits of scale which contain iron can build up inside the kettle. |
|
Customer Support
If you have any questions about our products, please contact our customer support team.
[email protected]