Installation Instructions
Item No. : 0094-2-OS-WF
Item Description: 2 Light Vanity
Please read carefully and save these instructions
WARNING: ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
PREPARING FOR INSTALLATION
Carefully remove all contents from the carton. See the important notes above. Shut off the power at the circuit breaker and completely remove the old fixture from the ceiling, including the old mounting plate. Remove the mounting plate assembly from the bag.
Accessory package
(AA) Wire connector 
x3
(C) Nut 
x2
(G) Ball nut 
x2
(A) Mounting screw (#8-32*32mm) 
x2
(D) Mounting screw (#8-32*25mm) 
x2
(B) Mounting plate 
x1
(E) Ground screw 
x1
ASSEMBLY AND INSTALLATION
1
(A) Mounting screw x2
(B) Mounting plate x1
(C) Nut x2
(D) Mounting screw x2
1. Mounting plate (B) contains several pairs of threaded holes. Find the pair of holes that matches the spacing of the holes on the junction box and the fixture’s canopy. Two mounting screws (A) should be attached to mounting plate (B). You may need to tighten nuts (C) to hold these screws in place. Pull the house wires through the center of mounting plate (B). Place mounting plate (B) over the junction box so that mounting screws (A) are vertical and aligned with the hole locations on the fixture’s canopy (F). Secure mounting plate (B) to the junction box by tightening the screws (D).
2
(E) Ground screw x1
(AA) Wire connector x3
A FIXTURE WIRES
1. SMOOTM (Or Black)
2. RIBBED (Or White)
3. BARE COPPER (Or Green )
B HOUSE WIRES
4. BLACK (Hot)
5. WHITE (Neutral)
6. GREEN (Ground)
2. Strip 3/8″of insulation from the wire ends. Using wire connector (AA), connect RIBBED fixture wire to the WHITE supply wire from the junction box; connect the SMOOTH fixture wire to the BLACK supply wire. Connect the fixture ground wire and supply ground wire using a wire connector or by fastening to the ground screw (E) on the mounting plate. Push all wire connections into the junction box.
3
(A) Mounting screw x2
(F) Backplate x1
(G) Ball nut x2
3. Place the fixture’s backplate (F) over the mounting screws (A) so that they protrude through the holes in the front of the backplate. Tightly screw the ball nuts (G) onto the mounting screws (A) until the backplate of the fixture is snug against the wall.
4
(H) Socket x2
(I) Glass x2
(J) Socket ring x2
4. Secure glass (I) onto the socket (H) by screwing socket ring (J) tight. Install light bulb (not included) in accordance with the fixture’s specifications. Do not exceed the recommended maximum wattage.
Your installation is now complete. Turn on the power and test the fixture.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture. Dry with a lint-free or microfiber cloth.