CRYSTORAMA WIN-617-GA-CL-MWP Winham Six Light Chandelier Instruction Manual

LIGHTING THE WAY FOR SIXTY YEARS
ASSEMBLY INSTRUCTION
MODEL #WIN-617-GA-CL-MWP

WIN-617-GA-CL-MWP Winham Six Light Chandelier

All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes.

You will need 6 -Candelabra Base Bulb 40 Watts Recommended 60 Watts Max.
USE LED BULBS FOR EXTENDED USE THIS FIXTURE IS DAMP RATED

How to Install

1. Determine preferred hanging height and adjust to the required chain.
2. On both sides, feed wires through the hanging stem and chain.
3. Attach the stem onto the fixture body.
4. On each piece of chain, hang one end at the loop on canopy and the second end at the loop on the top of stem.
5. Insert recommended bulb (not included).
6. Dress the crystal strands as illustrated.

DETAILED ILLUSTRATION

SUGGESTED CRYSTAL PLACEMENT TOP VIEW
PLEASE REFERENCE CRYSTAL KEY
The minimum hanging height:

WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm. For more information go to www.P65Warnings.ca.gov.

Crystal Key

A.14 Sets.
(5)14mm + (4)20mm + (1)30mm
B.14 Sets.
(7)14mm + (5)20mm + (1)30mm
C.14 Sets.
(3)14mm + (6)20mm + (1)30mm
D.12 Sets.
(10)14mm + (4)20mm + (2)30mm
E.12 Sets.
(6)14mm + (4)20mm + (1)30mm
F.14 Sets.
(4)14mm + (2)20mm + (1)30mm
G.14 Sets.
(3)14mm + (3)20mm + (1)30mm
H.14 Sets.
(5)14mm + (4)20mm
I.16 Sets.
(3)14mm + (2)20mm + (1)30mm
J.12 Sets.
(5)14mm + (2)20mm + (1)30mm

PART NUMBER

A. (1) – Mounting Hardware include:
(1) – Mounting Plate
(4) – Machine Screw
(3) – Wire Connector
(2) – Plastic Anchor
(2) – Wood Screw
B. (1) – Canopy(L28″,W4.5″,H0.75″) #XRE617GACAN28IN
C. (4) – Fixture Loop
D. (4) – Quick Link
E. (2) – Hanging Chain(each72″,5.0mm) #XRE617GACHA5MM
F. (2) – Hanging Stem(6″,12.7mm) #XRE617GASTEM6IN
For installation of mounting plate:

1. Please measure the distance between the two mounting keyholes on the mounting plate.
2. Make two points on the ceiling according to the distance measured above.
3. Drill two holes at the two points and insert the plastic anchors.
4. Put the mounting plate over outlet box and insert two wood screws in the plastic anchors and tighten them.

Crystorama.com