Contents
BLACK ICE PLUNGE DAF5UYVNRTY Cold Plunging
Specifications
- Temperature Controller preset to 39 Degrees
- Wireless Switch included
- Ozone filtration system
- Capacity: Fill up to FULL level
FAQ
Frequently Asked Questions
- Q: How do I know when the Plunge is at its desired temperature?
- A: The Temp Controller will indicate when it reaches the preset temperature of 39 Degrees.
- Q: Can I move the Plunge after it’s filled with water?
- A: It is recommended not to move the Plunge once it’s filled to avoid spillage or damage.
Product Using Instructions
STEP ONE
- Choose a safe and level location to place the Plunge. Keeping in mind of splashing and dripping water from entering/exiting the Plunge.
- Make sure an electrical outlet is nearby and also in a safe position. Place the foam pads under the left portion of the Plunge.
STEP TWO
- Plug in the Plunge directly into the Temp Controller.
- Temp Controller is preset to 39 Degrees. Position the probe at the bottom of the inside of the Plunge.
STEP THREE
- Position the filter and suction it directly onto the accessory board. TC Probe will eventually attach to board once the Plunge is filled with water.
- DONT RUN FILTER UNTIL PLUNGE IS FULL OF WATER. Attach hose from the OZONE to the filter. Run ozone for 5-10 after plunging, and wait 1 hour before re-entry.
STEP FOUR
- Plug the WIRELESS SWITCH into the outlet, and attach the included power strip to the switch.
- Attach the TEMP Controller to the power strip. Test the switch by pressing the button firmly.
STEP FIVE
FILLING THE PLUNGE WITH WATER and getting it down to Freezing temp is a 4-Step process: Fill the water 1/4 full, and allow the Plunge to get to its desired temp. Once it reaches the desired temp fill to 1/2, and repeat the process of letting it get to its desired temp. Continue this process at 3/4 until you reach FULL. Be CAUTIOUS to not overfill the plunge or it will OVERFLOW when you first enter.