Contents
NINJA Single Rider Golf Electric Scooter
Product Information
The product is a scooter with a front windshield, rear support, roof, roof bracket, front support, and a golf rack. The product comes with M8*60 bolts to install the front roof bracket, M6*50 bolts to install the roof, M8*70 bolts to install the rear support, M8*45 bolts to install the Golf rack, M6*40-hex bolts to install front support, and M6*40-round head bolts to install the glass. The product also has a seat, charger, and battery compartment. The product comes with a faucet tube and handle, which can be installed using screws. The product comes with a push rod under the seat to fix the seat and a Golf Stand.
Product Usage Instructions
- Install the front roof bracket using M8*60 bolts.
- Install the roof using M6*50 bolts.
- Install the rear support using M8*70 bolts.
- Install the Golf rack using M8*45 bolts.
- Install the front support using M6*40-hex bolts.
- Install the glass using M6*40-round head bolts.
- Install the seat by pulling the push rod under the seat and fixing it in place.
- Insert the battery into the battery compartment and connect the battery cable.
- Install the faucet tube and handle by grasping the handle and moving out of the scooter slowly, then installing the screw of the faucet handle.
- Install the Golf Stand by installing two parts as shown in the figure.
- Pay attention to the front and rear of the roof, then install two parts as shown in the figure and tighten the screws.
- Switch to electric mode and turn on the power.
- Drive the scooter.
WHAT IN BOX
PARTS
INSTALLATION
