INSTALLATION MANUAL
LED FIRE RATED
DOWNLIGHT
DL12W-FR-CC-IP65
Contents
DL12W-FR-CC-IP65 LED Fire Rated Downlight
Warning
- Before installation or maintenance ensure that the mains supply to the luminaire is switched off and the circuit supply fuses are removed or circuit breaker turned off.
- A qualified electrician MUST be consulted or used for the installation of this luminaire.
- The luminaire must be installed to there elegant building regulations.
- Check that the total load on the circuit, including when this luminaire is fitted, does not exceed the rating of the circuit cable fuse or circuit breaker.
Technical Specifications
| Input Voltage: | 200-240VAC 50/60Hz |
| Power: | 12W |
| Beam Angle: | 60 degree |
| IP Rating: | IP65/IP44 |
| PF: | >0.9 |
| Cut Out: | 90mm |
| Tri Cooler | 3000K, 4000K, 6000K |
| Lumens: | 900, 1000, 950 |
Dimensions
Installation Instructions
- Switch off power
- Prepare cut-out hole in your surface to specified dimensions as stated in above drawing.
- Select desired cooler output via front mounted switch -WW -3000K, CW-4000K, DL-6000K
- Connect the mains power cable to the driver
- Place driver into recess then push back spring clips and insert luminaire into recess.
- Place one of the supplied magnetic bezels to complete installation.
- Switch power on at circuit
Note:
For high voltage circuit insulation testing disconnect mains input supply first
(Do not circuit test using a megger)
Changing Colour Temperature
To change colour temperature after installation
a. Ensure the power is switched off.
b. Remove magnetic bezel and switch to desired color temperature
c. Replace bezel
d. Switch power on at circuit
Installation Spacing
RISK OF FIRE -Required clearance from structural members and building elements
HCB=20mm
SCB=20mm
1800 909 306
nedlandsgroup.com.au
[email protected]