STRICH M1 Wireless Microphone System Instruction Manual

STRICH M1 Wireless Microphone System Instruction Manual

Instruction

1. Plug the Transmitter into the XLR dynamic microphone or battery-powered condenser microphones.
   
2. Plug the Receiver into the Mixer or power speaker.
   
3. Long press and hold the power button for 2 seconds to turn on the transmitter/receiver The OLED will light up to check if the frequency is the same.
   

ISSUE	SOLUTION
No Sound	Check that the Receiver’s RF LED is lit Check that the microphone is turned on and recelving signal from the Transmitter Check that the power switch is turned on for both the Transmitter and the Recelver. Ensure that the Transmitter and Receiver are on the same channel. The Receiver can be paired with one Transmitter at a time.
Distortion or Faint Sound	Adjust the gain mode to “Line” or“Mic” Adjust the output signal from the transmitting device
Unable to switch the channel	The channel switch locks after 15 seconds Double-click the channel button to unlock and res
Multiple connect	Make sure the frequency of the receiver is the same as that of the transmitter. One transmitter can only be connected to one receiver

TRANSMITTER INTRODUCTION

Transmitter:

1. XLR PIug
2. OLED Display
3. USB 5V Recharge Jack
4. Charging Indicator
5. Power Button

TURN ON/OFF DEVICE: Press and hold the power button for 2 seconds to switch on and off
ADJUST THE VOLUME: In the power-on state, click the power button to select VOL. When VOL flashes, pass the “+” and “-” keys to adjust.
ADJUSTMENT MODE: In the power-on state, click the power button to select Mic/Music/48v. When Mic/Music/48v flashes, press the “+” and “-” keys to select.
CHARGING: Insert the 5v usb-c charging cable, the indicator light will show red light when charging, and the red light goes out to indicate that the battery is fully charged.

RECEIVER INTRODUCTION

Receiver:

1. XLR PIug
2. OLED Display
3. USB 5V Recharge Jack
4. Charging Indicator
5. Power Button
   

Power button: Press and hold for 2 seconds to turn on/turn off the unit.

FM Method:

1. After both the receiver and the transmitter are turned on, and the distance between them is more than 15cm.
2. Press and hold the receiver power button and “-” button at the same time until the screen displays CH, then let go, and then enter the FM interface.
3. Click the “-” button to select the corresponding frequency band, wait for 20 seconds to complete the automatic pairing after the screen displays SYNC.

APPLICATION SCENE

Functional Parameter

MICROPHONE WIRELESS SYSTEM

Tuning Band Width: 550-573.5MHz
Working Range: Up nonfactual Range Depe Actual range is subject to environmental interference.
Audio Frequency Response: 20Hz-20KH(-3dB) Dependent on microphone type or Input signal.
Dynamic Range: 110dB
Battery Life Up: To 5 Hours
RF Sensitivity: -88dBm
Total Harmonic Distortion: 0.2%
RX Output Power: 10mW E.I.R.P. max
Operating Temperature Range: -18°C to 57°C Battery Characteristics May Limit This Range.
Channel Count: 20 Channels