artika 0375-WD Bloom LED Wall Light Instruction Manual

Contents
Included Hardware
| Item | Description | Quantity |
| A | Mounting bracket | x1 |
| B | Junction box screw | x2 |
C ![]() |
Wire connector | x3 |
| D | Canopy screw | x4+1 extra |
E ![]() |
Rubber washer | x4 |
| F | Light fixture | x1 |
Step By Step Installation
What you will need
- Screwdriver
- Sealant
WARNING:
Risk of electrical shock. Turn off breaker at the panel.
Switch off the main electrical supply from the fuse box/circuit breaker before installing the unit or doing ‘any maintenance.
CAUTION
If using a dimmer, it must be LED compatible.
IMPORTANT
The installer and/or user must read, understand and follow these instructions before installing the product. This product must be properly installed before itis used. Hfinstructions are not followed, the manufacturer will not be held responsible for any problems or praduct malfunction, Failure to follow instalation and/or operating instructions voids the warranty.
We recommend that this product be installed by a certified electrician. Insame states or provinces, itis a legal requirement for this type (of product to be installed by a certified electrician, according to the electrical and building codes effective in the region where the unit is used,
Minimum Clearance

Plan the desired height
Mounting Bracket Installation

Connecting The Wires

Tunable White Technology (CCT)

Fixture Installation

Apply Sealant

NOTE: We recommend keeping the bottom unsealed, To maintain a drainage area in case of water infiltration,
Operation is subject tothe following two conditions:
- this device may not cause interference, and
- this device must accept any inteference, including inteference that may cause undesired operation ofthe device.
WARNING:
Changes er modifications to this unit not expressly approved by the party responsible for compliance could vid the user’ authority to operate the equipment
This device complis wth Pat 15 of the FCC Rules. Operation i subject tothe following two conditions
- This device may not cause harmful interference, and
- this device must accept anyinterference ceived rciuding interference that may cause undesies operation,
NOTE: This equipment has been tested and found to comply with the Limits for Class digital sovies. pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference ina esdental instalation Ths ‘equipment generates, uses and can ‘adate radiofrequency energy andi not installed ans used in acordance vith the instruction, may cause harmful interference toradioor television reception However. there no guarantee that intererence wil not eccur ina particular installation. this equipment causes harmfut interference te radi or television reception, whic canbe determined by turning the equipment off and on, the users enccuraped to try to corect the interference by ane or mare of he following measures:
- Reerient or relocate the receiving antenna
- Increase the separation between the equipment andthe receiver.
- Conned he eauipment ito anoutet ‘on a ieutaillerent fem tha to whieh the receivers connectes.
- Consult the deaieroran experienced ‘io/TV technician for hep.

