Square D S29305 DIN Rail Mounting Kit for H and J frame Circuit Breakers Instructions

Square D S29305 DIN Rail Mounting Kit for H and J frame 
Circuit Breakers Instructions

Retain for future use.

Kit Contents

Tools Needed

Part 
Screwdriver (Pozidriv® No. 1 or 2 or Slotted) /
Wrench (7 mm) /

⚠ DANGER

HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH

• Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices. See NFPA 70E.
• This equipment must be installed and serviced only by qualified electrical personnel.
• Turn off all power supplying this equipment before working on or inside equipment.
• Always use a properly rated voltage sensing device to confirm power is off.
• Replace all devices, doors and covers before turning on power to this equipment.

INSTALLATION

CAUTION

HAZARD OF EQUIPMENT DAMAGE
Do not use DIN-rail mounting bracket with motor operated circuit breakers.
Failure to follow this instruction can result in equipment damage.

1. Turn off all power supplying this equipment before working on or inside equipment.
2. Turn off (O) circuit breaker.
3. Install circuit breaker and mounting bracket assembly (A) on DIN rail (B) as shown in Figure 1.

Figure 1 : DIN Rail Mounting 

Circuit breaker can now be placed into service.

Electrical equipment should be installed, operated, serviced, and maintained only by qualified personnel. No responsibility is assumed by Schneider Electric for any consequences arising out of the use of this material.

Schneider Electric USA 3700 Sixth St SW Cedar Rapids, IA 52404 1-888-SquareD (1-888-778-2733) www.us.SquareD.com

© 2004­2005 Schneider Electric All Rights Reserved
Released for Manufacturing
Printed on 2022/05/24